Peavey IMPULSE 12 D Uživatelský manuál

www.peavey.comImpulse®12 D Bi-amplified Class D powered speaker systemOperatingManual

10The middle screw of a smaller size in the middle of each mounting plate is a retention screw. It should not be removed from the insert mounting plat

11CONNECTING A SIGNAL TO THE IMPULSE® 12DThere are a variety of ways to input a signal to the Impulse® 12D. The two inputs (7,8) provide either a bala

12The unit is normally shipped with the button in the line-level or “in” position. However, before each use it is a good idea to check for the proper

13the Impulse® 12D. If an extension cord is being used to provide the AC power to the unit, ensure that it is of sufficient current capacity and that

14ARCHITECTURAL AND ENGINEERING SPECIFICATIONSThe powered loudspeaker system shall have a frequency response from 60 Hz to 20 kHz. The peak SPL with i

15Enclosure: Peavey Impulse® 12DFrequency response: 52 Hz to 20 kHzLow frequency limit (-3 dB point): 60 HzUsable low frequency limit (-10 dB point):

16Features and specifications subject to change without notice.Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian • MS • 39305 (601

17Button INButtons OUTMICROPHONE DIRECT INDynamic Mic(No Electrets)Button INButton OUTKARAOKE Dynamic Mic(No Electrets)CD Player/MP3 PlayerButtons INM

PEAVEY ELECTRONICS CORPORATION LIMITED WARRANTYEffective Date: 03/04/2010What This Warranty CoversYour Peavey Warranty covers defects in material and

Logo referenced in Directive 2002/96/EC Annex IV(OJ(L)37/38,13.02.03 and defined in EN 50419: 2005The bar is the symbol for marking of new waste and i

Intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to c

IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electrical products, basic cautions should always be followed, including the following:1. Read the

4Impulse® 12DThank you for purchasing the class D powered Peavey® Impulse® 12D. The Impulse® 12D features a bi-amped power section that provides 1200

EU 112D & EU 115D Access Text P0900080, P0900081 69601387Impulse Access Text P0800053 696013875CIRCUIT BREAKER (1)The unit is AC power line protec

EU 112D & EU 115D Access Text P0900080, P0900081 69601387Impulse Access Text P0800053 696013876REAR PANEL TOPON-OFF SWITCH (3)This rocker switch s

7INPUT 2 (B)Input 2 is switchable between line-level gain and mic-level gain. The line-level input is medium impedance balanced. The input 2 jack (8)

8THIS SWITCH IS OVERRIDDEN IF THE CONTOUR/BYPASS SWITCH (20) IS IN THE BYPASS MODE. THE ASSOCIATED LED (21) WILL REFLECT THIS CONDITION.The Contour/By

9CAUTIONSThe unit must be disconnected from the AC power source before any work is done on it. Refer all servicing to qualified service personnel.The